System Settings
91
3.
Select [Close].
USB
Specifies whether to enable the USB port and configures the port settings.
• Port Status
Specifies whether to enable the USB port.
• Print Mode
Specifies the PDL to be used for print jobs. Only pre-installed PDLs are available.
•PJL
Specifies whether to enable the PJL (Printer Job Language).
• Auto Eject Time
Specifies the time-out period when print data is not sent to the machine sequentially.
If the specified time elapses, the remaining data inside the machine is automatically
printed out. You can enter a time within the range of 5-1,275 seconds in 5-second
increments.
• Adobe Communication Protocol
Specifies the communication protocol format for Adobe Communication Protocol.
– Standard - Select this option when the communication protocol is in ASCII format.
– Binary - Select this option when the communication protocol is in binary format.
Depending on the data, the print job may be completed faster than [Standard].
– TBCP - Select this option to switch the specific control codes when the
communication protocols involve both ASCII and binary formats.
– RAW - Select this option when the communication protocol is in RAW format.
Using this option allows you to correctly print EPS files from a Macintosh
computer via USB.
LPD
Specifies whether to enable the LPD port, and specifies the port number and the
maximum number of sessions.
NetWare
Specifies whether to enable the NetWare port.
SMB
Specifies whether to enable the SMB port.
IPP
Specifies whether to enable the IPP port, and specifies the port number.
EtherTalk
Specifies whether to enable the EtherTalk port.
Bonjour
Specifies whether to enable the Bonjour port.
Port 9100
Specifies whether to enable the Port 9100 port, and specifies the port number.
To Next Page
Loading...
Need help?
General
