Xerox Phaser 3200MFP User Manual

3 Network Setup
3-2 Xerox Phaser 3200MFP
Introduction
Once you have connected your machine to a network with an RJ-45 Ethernet
cable, you can share the machine with other network users.
You need to set up the network protocols on the machine to use it as your
network printer. Protocols can be set up by the following method:
Via the control panel
You can set up the following basic network parameters through the machine’s
control panel:
• Configure TCP/IP
• Configure EtherTalk
Supported operating systems
The following table shows the network environments supported by the
machine:
• TCP/IP: Transmission Control Protocol/Internet Protocol
• DHCP: Dynamic Host Configuration Protocol
• BOOTP: Bootstrap Protocol
Item Requirements
Network interface • 10/100 Base-TX
Network
operating system
• Windows 98/Me/NT 4.0/2000/XP(32/64bit)/2003(32/
64bit)/Vista
• Various Linux OS (refer to Installing the Unified Linux
Driver on page 32)
• Macintosh OS 10.3~10.4
Network
protocols
• TCP/IP on Windows
• EtherTalk
Dynamic
addressing server
• DHCP, BOOTP

Xerox Phaser 3200MFP Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Print Resolution	Up to 600 x 600 dpi
First Page Out Time	Less than 10 seconds
Copy Resolution	Up to 600 x 600 dpi
Maximum Copy Count	99 copies
Fax Transmission Speed	33.6 kbps
Standard Paper Capacity	250 sheets
Connectivity	USB 2.0
Memory	32 MB
Operating System Compatibility	Windows, Mac OS
Duplex Printing	Manual
Scan Type	Flatbed
Media Sizes Supported	Letter, Legal, Executive, A4, A5
Media Weight	60 to 163 g/m²
Monthly Duty Cycle	10, 000 pages
Toner Yield	Up to 3, 000 pages