5 Copying
Xerox Phaser 3200MFP 5-7
Special Copy Features
You can use the following copy features by pressing Favorite Copy button:
• Off: Prints in normal mode.
• Clone:
Prints multiple image copies from the original document on a single
page. The number of images is automatically determined by the original image
and paper size. See Clone Copying on page 5-7.
• Copy Collate:
Sorts the copy job. For example, if you make 2 copies of a 3
page document, one complete 3 page document will print followed by the
second complete document. See Collation Copying on page 5-8.
• Auto Fit: A
utomatically reduces or enlarges the original image to fit on the
paper currently loaded in the machine. See Auto Fit Copying on page 5-8.
• ID Card Copy:
Prints 2-sided ID cards on one sheet of paper. See ID Card
Copying on page 5-9.
•
2
/
4 Up
: Prints 2 or 4 original images reduced to fit onto one sheet of paper.
See 2 Up or 4 Up Copying on page 5-9.
• Poster: Prints an image onto 9 sheets of paper (3x3). You can paste the
printed pages together to make one poster-sized document. See Poster
Copying on page 5-10.
NOTE: Some features may not be available depending on where you loaded
the document, on the document glass or in the Automatic Document Feeder.
Clone Copying
This special copy feature can be applied only when you place a document on
the document glass. If a document is detected in the ADF, Clone copying
feature does not work.
1. Place the document to be copied on the document glass, and close the
cover.
2. Press Favorite Copy until “Clone” appears on the bottom line of the
display and press Enter.
3. If necessary, customize the copy settings, including Lighten/Darken and
original type, by using the control panel buttons. See “Selecting Copy
Options” on page 5-5.
4. Press Start to begin copying.
NOTE: You cannot adjust the copy size using the Reduce/Enlarge button
while making a clone copy.
To Next Page
Loading...
Need help?
General
