Xerox Phaser 6120 - Page 174

Configuring the Printer
163
IP Address Sets the IP address.
Default: 192.168.1.2
Configuration Menu Equivalent:
MENU INTERFACE MENU/ETHERNET/
TCP/IP/IP ADDRESS
Subnet Mask Sets the subnet mask address.
Default: 000.000.000.000
Configuration Menu Equivalent:
MENU INTERFACE MENU/ETHERNET/
TCP/IP/SUBNET MASK
Default Router Sets the default router IP address.
Default: 000.000.000.000
Configuration Menu Equivalent:
MENU INTERFACE MENU/ETHERNET/
TCP/IP/DEFAULT ROUTER
Automatic
IP Settings
Enable
DHCP/
BOOTP
Selecting this check box enables DHCP.
Default: [Checked]
Configuration Menu Equivalent:
MENU INTERFACE MENU/ETHERNET/
TCP/IP/DHCP/BOOTP
Enable
PING/
ARP
Selecting this check box enables PING/ARP.
Default: [Checked]
Enable
AUTO IP
Selecting this check box enables automatic IP
detection.
Default: ON
Configuration Menu Equivalent:
MENU INTERFACE MENU/ETHERNET/
TCP/IP/ENABLE AUTO IP
Printing
Protocols
Enable
FTP
Selecting this check box enables FTP.
Default: [Checked]
Enable
Port 9100
Selecting this check box enables Port 9100.
Default: [Checked]
Save Changes Saves and applies any changes made.
Discard Changes If you made changes to any of the parameter settings
but do not wish to apply the changes, selecting this
button restores the last submitted parameter settings.
Item Description