Xerox WorkCentre 7132 System Administration Guide

Xerox WorkCentre 7132 System Administration Guide 103
9 TCP/IP (LPD or Port9100)
This chapter explains how to set up the machine to print from a Windows computer
through LPD or Port9100. The following information is provided.
Information Checklist – page 103
TCP/IP (LPD or Port9100) Environments – page 104
TCP/IP (LPD or Port9100) Installation – page 104
Installation Procedure – page 104
Network Communication Setup – page 105
Workstation Setup – page 106
Test Print – page 107
Information Checklist
Before starting these procedures, make sure that the following items are available or
have been performed.
If problems are encountered during machine setup, refer to the Problem Solving
chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Item By
An existing operational network utilizing TCP/IP is required. These
procedures are not designed to install a network.
Customer
Obtain and record the following information:
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed.
Customer
Test the machine to make sure that it is installed fully and functioning
correctly.
Customer
Install the print driver. Customer

Xerox WorkCentre 7132 Specifications

General

Brand	Xerox
Model	WorkCentre 7132
Category	All in One Printer
Language	English