Xerox WorkCentre 7132 System Administration Guide 93
7EtherTalk
This chapter explains how to set up the machine to operate on an EtherTalk network.
The following information is provided.
Information Checklist – page 93
EtherTalk Environments – page 94
EtherTalk Installation – page 94
Installation Procedure – page 94
Network Communication Setup – page 94
Workstation Setup – page 95
Test Print – page 95
Information Checklist
Before installing EtherTalk on the machine, make sure that the following items are
available or have been performed.
If problems are encountered during the machine installation, refer to the Problem
Solving chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Item By
An existing operational EtherTalk network with Macintosh workstations
equipped with Ethernet network interface cards is required. These
procedures are not designed to install an EtherTalk network.
Customer
Macintosh System versions 7.5 or later, 8.x, 9.x, or Mac OS X 10.x Customer
Test the machine to make sure that it is installed fully and functioning
correctly.
Customer
Install the Adobe PS print driver, or PPD (optional). Customer
To Next Page
Loading...
Need help?
General
