Xerox WorkCentre 7132

Selecting Transport Protocols
Xerox WorkCentre 7132 System Administration Guide 49
If the test fails, refer to the Problem Solving chapter for assistance.
NOTE: If the Auditron feature is enabled, you may be required to enter the user ID
and password (if one is set up). If you need assistance, contact the Key Operator.
NOTE: When your access to CentreWare Internet Services is encrypted, enter
“https://” followed by the internet address, instead of “http://”.
Selecting Transport Protocols
When using the NetWare, SMB, or SNMP port, change the transport protocol if
required.
• NetWare: IPX/SPX, TCP/IP
• SMB: NetBEUI, TCP/IP
• SNMP: UDP, IPX
1. At the CentreWare Internet Services home page for the machine, select the
[Properties] tab.
2. In the [Properties] frame, select [Port Status].
3. Select the required transport protocol.
NetWare: IPX/SPX, TCP/IP
SMB: NetBEUI, TCP/IP
SNMP: UDP, IPX
4. Select [Apply].