Xerox WorkCentre 7132 System Administration Guide

SMB Installation
Xerox WorkCentre 7132 System Administration Guide 99
SMB Installation
This section describes the installation procedure for using the machine on an SMB
network.
Installation Procedure
The installation procedure is as follows.
Network Communication Setup
Enable the SMB port.
When using NetBEUI:
Set the SMB port to [Enabled] using the touch screen or CentreWare Internet
Services.
When using TCP/IP:
Set the SMB port to [Enabled] using the touch screen or CentreWare Internet
Services. Set the IP address on the control panel or CentreWare Internel Services.
Workstation Setup
Install the print driver on the computer.
Test Print
A print job should be submitted to make sure that the machine has been installed and
configured correctly.
Network Communication Setup
This procedure is used to set up the network communication parameters of the
machine.
At the machine, perform these steps.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP
network.
NOTE: Some of the configuration options for this protocol are only available from the
CentreWare Internet Services. Refer to the CentreWare Internet Services chapter of
the User Guide.
Initially, boot the SMB port.
1. Connect the machine to the network.
2. Display the [System Settings] screen.
NOTE: For more information about how to display the [System Settings] screen, refer
to the Setups chapter of the User Guide.

Xerox WorkCentre 7132 Specifications

General

Brand	Xerox
Model	WorkCentre 7132
Category	All in One Printer
Language	English