EasyManuals Logo

Xerox WorkCentre 7132 System Administration Guide

Xerox WorkCentre 7132
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #113 background imageLoading...
Page #113 background image
Xerox WorkCentre 7132 System Administration Guide 113
11 IPP (Internet Printing Protocol)
This chapter explains how to set up the machine to operate in an IPP (Internet Printing
Protocol) environment. The following information is provided.
Information Checklist – page 113
IPP Environment – page 114
IPP Installation – page 114
Installation Procedure – page 114
Network Communication Setup – page 115
Workstation Setup – page 116
Test Print – page 116
Information Checklist
Before starting the IPP installation procedures, make sure that the following items are
available or have been performed.
If problems are encountered during the installation of the machine, refer to the Problem
Solving chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Item By
An existing operational TCP/IP network is required. These procedures
are not designed to install a network.
Customer
Obtain and record the following information:
IP address
Gateway address
Subnet mask
Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed.
Customer
Test the machine to make sure that it is installed fully and functioning
correctly.
Customer
Install the print driver. Customer

Table of Contents

Other manuals for Xerox WorkCentre 7132

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WorkCentre 7132 and is the answer not in the manual?

Xerox WorkCentre 7132 Specifications

General IconGeneral
BrandXerox
ModelWorkCentre 7132
CategoryAll in One Printer
LanguageEnglish

Related product manuals