EasyManuals Logo

Xerox WorkCentre 7132 System Administration Guide

Xerox WorkCentre 7132
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #97 background imageLoading...
Page #97 background image
Xerox WorkCentre 7132 System Administration Guide 97
8 Microsoft Networking
This chapter explains how to set up the machine to operate on a Microsoft network. The
following information is provided.
Information Checklist – page 97
SMB Environments – page 98
SMB Installation – page 99
Installation Procedure – page 99
Network Communication Setup – page 99
Workstation Setup – page 101
Test Print – page 101
Information Checklist
Before starting the Microsoft networking installation procedures, make sure that the
following items are available or have been performed.
If problems are encountered during the installation, refer to the Problem Solving
chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Item By
An existing operational Microsoft network is required. These procedures
are not designed to install a Microsoft network.
Customer
Obtain and record the following information, if required:
IP address
Gateway address
Subnet mask
Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed.
Customer
Test the machine to make sure that it is installed fully and functioning
correctly.
Customer
Install the print driver. Customer

Table of Contents

Other manuals for Xerox WorkCentre 7132

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WorkCentre 7132 and is the answer not in the manual?

Xerox WorkCentre 7132 Specifications

General IconGeneral
BrandXerox
ModelWorkCentre 7132
CategoryAll in One Printer
LanguageEnglish

Related product manuals