TCP/IP (LPD or Port9100) Installation
Xerox WorkCentre 7132 System Administration Guide 107
Test Print
To make sure that the machine has been installed on the network correctly, a test print
should be submitted from a client workstation. Perform the following steps.
1. Open a document on a client workstation.
2. Select the machine as the printer to which the selected document will be sent.
3. Print the document on the machine and verify that it prints correctly.
4. Make sure that the driver is installed on every workstation that will be sending jobs
to the machine.
5. Repeat the test for all workstations that will be sending jobs to the machine.
The installation process is now complete.
If the test print fails, refer to the Problem Solving chapter for assistance.
To Next Page
Loading...
