Xerox WorkCentre 7132 System Administration Guide 67
5NetWare
This chapter explains how to install the machine onto a NetWare network. The following
information is provided.
Information Checklist – page 67
NetWare Environments – page 68
NetWare Installation – page 69
Installation Procedure – page 69
Network Communication Setup – page 69
NetWare Setup – page 71
Workstation Setup – page 71
Test Print – page 71
Information Checklist
Before installing the machine onto a network, make sure that the following items are
available or have been performed.
If problems arise during the machine installation, refer to the Problem Solving chapter
for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Item By
An existing operational NetWare network is required. These procedures
are not designed to install a NetWare network.
Customer
NetWare versions 3.x, 4.x, 5.x or 6.x. Customer
Obtain and record the following information, if required:
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed.
Customer
Test the machine to make sure that it is installed fully and functioning
correctly.
Customer
Install the print driver. Customer
To Next Page
Loading...
Need help?
General
