Xerox WorkCentre 7132 System Administration Guide

iFax Installation
Xerox WorkCentre 7132 System Administration Guide 139
Test iFax
The iFax job should be submitted to make sure that the machine has been installed and
configured correctly.
Network Communication Setup
NOTE: Some of the configuration options for this protocol are only available from the
CentreWare Internet Services. Refer to the CentreWare Internet Services chapter of
the User Guide.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP
network.
Initially, activate the port.
1. Connect the machine to the network.
2. Display the [System Settings] screen.
NOTE: For more information about how to display the [System Settings] screen, refer
to the Setups chapter of the User Guide.
3. Select [Network Settings].
4. Select [Port Settings].
5. Select [Receive E-mail] and then [Change Settings].
6. Select [Port Status] and then [Change Settings].
7. Select [Enabled] and then [Save].
8. On the [Port Settings] screen, select [Send E-mail] and then [Change Settings].
9. Select [Port Status] and then [Change Settings].
10. Select [Enabled] and then [Save].
Next, establish TCP/IP.
1. Display the [System Settings] screen.
NOTE: For more information about how to display the [System Settings], refer to the
Setups chapter of the User Guide.
2. Select [Network Settings].
3. Select [Protocol Settings].
4. Select [TCP/IP - Get IP Address], and then [Change Settings].

Xerox WorkCentre 7132 Specifications

General

Brand	Xerox
Model	WorkCentre 7132
Category	All in One Printer
Language	English