Quick Network Setup (Static IP)
Xerox WorkCentre 7132 System Administration Guide 43
field and select [Next]. The next 3 digits are highlighted. When you have finished
entering all values, select [Save].
9. Select [TCP/IP - Subnet Mask], and then [Change Settings].
10. Using the same method as in step 8, enter the Subnet Mask.
11. Select [TCP/IP - Gateway Address], and then [Change Settings].
12. Using the same method as in step 8, enter the Gateway Address.
NOTE: If you do not wish to set the Gateway Address, enter “0.0.0.0”.
13. Select [TCP/IP - IP Filter], then [Change Settings].
14. Select [On] to filter access to the machine.
NOTE: If you do not wish to use the IP filter feature, select [Off].
NOTE: Use CentreWare Internet Services to register the IP addresses which are not
allowed to access the machine. Refer to the CentreWare Internet Services chapter of
the User Guide.
15. When you have finished establishing TCP/IP, select [Close] from the [Protocol
Settings] screen.
To Next Page
Loading...
