Yamatake Corporation Operation Using SFC
ST3000 Smart Transmitter Series 900 Electronic Differential Pressure/Pressure Transmitter 6-21
6-6 : Continuously printing response result: ACT PRINT key
Action printout (continuous printout) is used to continuously print out results of
responses from the transmitter to key operations from the SFC and keep the data.
Use the following procedure to carry out action printout.
Step Procedure SFC screen
1 Start communication between the SFC
and transmitter. For the detailed proce-
dure, see “Starting communication” on
page 2-10.
2 Make sure that the SFC is set to
“READY“
If it is not, press the key to set it to
“READY.“
3
Press the key.
4
Press the (ACT PR) key.
5
Press the key.
Result:
Action printout starts by printing:
* ACTION PRINT * START
TAG No. FIC-1234
'95-12-18 15:30
Hereafter, the operation content and
results of response from the transmitter
are printed out every time the key is
operated.
6
Press the key to stop the action
printout operation.
CLR
( No )
DSTJ FIT-1234
READY...
SHIFT
SHIFT-
Z
0
ACT PR
DSTJ FIT-1234
ACTION PRINT?
ENTER
( Yes )
NON-VOL
SHIFT
SHIFT-
To Next Page
Loading...
Need help?
General
