YASKAWA iQpump1000 - Page 192

If the drive does not receive confirmation from all nodes after 5 s, the drive will display the message shown in Figure 4.27.
Figure 4.27 Still Waiting Message
The Still Waiting message screen is dismissed after 15 s or when any key is pressed. The display then returns to the parameter
selection screen.
The drive displays the confirmation screen shown in Figure 4.28 if the confirmation comes back before the 15 s timer expires.
Figure 4.28 Node Update Message
Nodes that failed to update are indicated by an “X” while nodes that completed successfully are marked by an “o”.
The Node Update message is displayed for 1.5 s or until a key is pressed if all nodes successfully update. The message is
displayed for 15 s or until a key is pressed if any node fails to update. The display then returns to the parameter selection
screen.
n
Non-System-Wide Parameters
Parameters in Table 4.16 cannot be pushed to other drives on the MEMOBUS Multiplex network.
Table 4.16 Non-System-Wide Parameters
No. Name
A1-03 Initialize Mode
A1-08 Custom Initialize Mode
H5-01 Drive Node Address
o2-04 Drive Model Selection
o2-09 Factory
o3-01 Copy Function Selection
o4-01 Cumulative Operation Time Setting
o4-03 Cooling Fan Operation Time Setting
No. Name
o4-05 Capacitor Maintenance Setting
o4-07 DC Bus Pre-charge Relay Maintenance Setting
o4-09 IGBT Maintenance Setting
o4-11 Fault Data Initialization
o4-12 kWh Monitor Initialization
o4-13 Number of Run Commands Counter Initialization
o4-17 RTC Time Setting
P1-01 Pump Mode
4.6 iQpump Presets and Functions
192
YASKAWA TOEP YAIP1W 01F YASKAWA AC Drive - iQpump1000 User Manual