User Constants
9-13
9
* 1. The factory setting will change when the control method is changed. (V/f control factory setting are given.)
* 2. The factory setting will change when the control method is changed. (Open Loop Vector control factory setting are given.)
* 3. The factory setting will change when the control method is changed. (Close Loop Vector control factory setting are given.)
* 4. The factory setting depend on the Inverter capacity.
o2-09 Initialize Mode 0
o2-10 Fan operation time setting 0 hr
o2-12 Fault trace initialize 0
o2-15 “No of Travels” monitor initialize 0
o3-01 Copy function selection 0
o3-02 Read permition selection 0
T1-01 Autotuning mode selection 0
T1-02 Motor output power *1
T1-03 Motor rated voltage *1
T1-04 Motor rated current *1
T1-05 Motor base frequency 60.0 Hz
T1-06 Number of motor poles 4 poles
T1-07 Motor base speed 1450 r/min
T1-08 Nember of PG pulses 1024
Table 9.1 User Constants
No. Name
Factory
Setting
Setting
http://nicontrols.com
To Next Page
Loading...
