YASKAWA Varispeed L7 User Manual

3-6
 Switching Modes
The mode selection display will appear when the MENU key is pressed. Press the MENU key from the mode
selection display to switch through the modes in sequence.
Press the DATA/ENTER key to enter a mode and to switch from a monitor display to the setting display.
Fig 3.3 Mode Transitions
To run the inverter after viewing/changing parameters press the MENU key and the DATA/ENTER key in sequence to
enter the Drive mode. A Run command is not accepted as long as the drive is in any other mode.
Frequency Ref
-DRIVE-
U1-02=60.00Hz
U1-03=10.05A
** Main Menu **
-DRIVE-
Operation
** Main Menu **
-QUICK-
Quick Setting
** Main Menu **
-ADV-
Programming
** Main Menu **
-VERIFY-
Modified Consts
** Main Menu **
-A.TUNE-
Auto-Tuning
Rdy
U1- 01=60.00Hz
Monitor
-DRIVE-
U1-02=60.00Hz
U1-03=10.05A
Rdy
U1 - 01=60.00Hz
Control Method
-QUICK-
A1-02=3
Initialization
-ADV-
A1 - 00=0
Select Language
None Modified
-VERIFY-
Frequency Ref
-DRIVE-
U1-02=60.00Hz
U1-03=10.05A
U1- 01=60.00Hz
Frequency Ref
-DRIVE-
Rdy
U1- 01=
0
60.00Hz
Control Method
-QUICK-
A1-02= 3
Close Loop Vector
Select Language
-ADV-
A1- 00 =0
*0*
English
-ADV-
Select Language
English
The constant number will be displayed if a
parameter has been changed. Press the
DATA/ENTER key to enable the change.
Monitor Display Setting Display
Mode Selection
Display
Display at Startup
Close Loop Vector
Tuning Mode Sel
-A.TUNE-
Standard Tuning
"0"
Tuning Mode Sel
-A.TUNE-
Standard Tuning
"0"
*3*
Rdy
A1- 00= 0
*0*
T1- 01=0 1
*0*
T1- 01= 0
*0*
*3*
MENU
MENU
MENU
MENU
MENU
RESET
RESET
ESC ESC ESC
ESC ESC
ESC ESC ESC
ESC
ESC ESC
(0.00 ~ 60.00)
" 00.00Hz "
http://nicontrols.com

YASKAWA Varispeed L7 Specifications

General

Brand	YASKAWA
Model	Varispeed L7
Category	Inverter
Language	English