Yealink SIP-T46G - Page 31

Administrator’s Guide for SIP-T46G IP Phone
18
 Secondary DNS
Procedure
Network parameters can be configured manually using the configuration files or
locally.
Configuration File
<y000000000028>.cfg
Configure network parameters of
the IP phone manually.
For more information, refer to
Static Network Settings on page
233.
Local
Web User Interface
Configure network parameters of
the IP phone manually.
Navigate to:
http://<phoneIPAddress>/servlet
?p=network&q=load
Phone User Interface
Configure network parameters of
the IP phone manually.
To configure the IP address mode via web user interface:
1. Click on Network->Basic.
2. Select the desired value from the pull-down list of Mode (IPv4/IPv6).
3. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after reboot.
4. Click OK to reboot the IP phone.