Yealink VC880 - Entering Characters by VCR11 Remote Control

| Getting Started | 11
No. Name Description
8 Zoom out key
• Decrease the focal length of the camera.
• Zoom the captured image out.
• Turn the page down.
9 OK key Go the sub-menu, confirm the action or select one item.
10 Navigation
Key
• Navigate through menu items.
• Pan and tilt the camera to adjust the angle.
11 Mute Key Mute or unmute the microphone.
12 Home key
• Return to the idle screen when the system is not in a call.
• Open Talk Menu during a call.
13 Back key Return to the previous menu.
14 Off-hook Key Enter the pre-dialing screen, the dialing screen or the answering screen.
15 Delete Key
• Delete one character at a time.
• Long press to delete all characters in the input field.
• If the system is connected to a USB flash drive, you can long press it for 2
seconds it to start capturing packets and long press it for 2 seconds again to stop
capturing packets.
16 On-hook Key
• End a call or exit a conference call.
• Return to the idle screen.
17 Keypad
• Enter digits.
• Go to the Dial page.
18 Character Key Enter the special characters: .@*.
19 Pound key Enter the pound key (#).
Note: The infrared sensor locates within the LED indicator of camera. Aim the remote control at the infrared
sensor to operate the camera.
Entering Characters by VCR11 Remote Control
You can use onscreen keyboard on the monitor or use keypad on the remote control to enter characters.
•
Enter Characters by Dial Pad
•
Using the Onscreen Keyboard
Enter Characters by Dial Pad
The keypad of your remote control only provides digit keys and #.@* keys.
Procedure
Press the keypad on the remote control to enter characters.