| Getting Started | 16
Operation Procedure
Cut/Copy
characters.
1.
Select characters.
2.
Tap CUT/POTY or tap / on the status bar.
3.
Long tap the desired field.
4.
Tap PASTE.
Delete more
characters at a
time.
Do one of the following:
•
Long tap the entered character(s), drag / to select the desired characters, and then
tap .
•
Drag / to select the desired characters, and then tap .
•
Long press .
Replace characters.
1.
Drag the cursor to select the desired character.
2.
Enter the desired character.
Enter Characters by Dial Pad
On the Dial page, you can enter the desired number. The dial pad only provides digit keys and #.@* key.
Running the Setup Wizard
The setup wizard appears automatically at the first startup or when the system is reset to factory. You can configure
the initial settings, for example the language, the network, and the account, for the device by your remote control.
Note: You can also tap Exit Boot Wizard on your CP960 conference phone to skip the setup wizard.
Powering on the System
Your system starts up automatically after you connect an electrical supply. If you power off the system using the
remote control, do the following to power it on.
Procedure
On your remote control, long press the Power Key for 3 seconds.
Your system is powered on successfully, and the LED indicator glows green.
Related tasks
Powering off the System
To Next Page
Loading...
