| Using WPP20 Wireless Presentation Pod | 77
Using WPP20 Wireless Presentation Pod
After WPP20 Wireless Presentation Pod is paired with VC800/VC500/VC200/PVT980/PVT950 and connected to
the computer, it can easily realize the wireless screen projection of computer screen with whiteboard collaboration
function. And it can receive the whiteboard or shared content initiated by the codec or other devices. In addition, the
WPP20 built-in Yealink Wireless Presentation Pod software, combined with a conference TV terminal and touch TV,
allows you to record and control your meeting while sharing the screen. At the same time, you can directly reversal
control the computer on the touch TV or touch panel to give you the extremely content sharing experience.
For more information, refer to Yealink WPP20 Wireless Presentation Pod Quick Start Guide.
Note: Contact your system administrator to check whether the whiteboard feature is available.
Note: If you use the WPP20 on your Mac device and after starting the Yealink Wireless Presentation Pod
software, the system will prompt Yealink WPP20 wants to make changes. After entering the device password,
it can be used normally. Otherwise, the other party will not hear the sound during the content sharing. WPP20
only supports content sharing on Mac devices.
•
Introduction of the WPP20 Whiteboard Note Toolbar
•
Introduction of WPP20 Note Toolbar
•
Receiving Shared Whiteboard or Content
•
Initiating Whiteboard Sharing on WPP20
•
Saving the Content or Whiteboard Picture Locally via WPP20
•
Saving or Sharing Whiteboard Source Files via WPP20
•
Importing the Whiteboard Source File via WPP20
•
Importing an Existing Whiteboard during a Call via WPP20
Introduction of the WPP20 Whiteboard Note Toolbar
Introduction of the WPP20 whiteboard note toolbar is as below:
Introduction of WPP20 Note Toolbar
The interface introduction of the WPP20 note toolbar is below:
To Next Page
Loading...
