3-6
IM 04P03B01-01E
3.6 Turning Trend Recording (Dot Model) and
Periodic Printout ON/OFF for Each Channel
This section explains the details of setting the trend recording and periodic printout for
each measurement channel.
Procedure
1. Hold down the
MENU
key for 3 seconds to enter Setting mode.
2. Carry out the procedure shown in the figure below.
Press the
or key to select the value.
If you press the key, the operation is cancelled, and the display returns to a
higher level menu.
Select the channel number.
Select “PRINT.”
(Dot model only)
Turn trend recording ON/OFF.
Select whether to print the measured
values in periodic printout.
Select the “AUX.”
(AUX)
(PRINT)
(CH1)
(ON)
(ON)
The settings are activated.
(OK)
Trend recording
Periodic printout
3. Press the key to set other channels.
If you are done, press the
key.
4. Hold down the
MENU
key for 3 seconds to return to Operation mode.
Explanation
The following settings can be entered for each channel.
• Turn trend recording ON/OFF (dot model only).
• Yurn the printing of measured values/alarm statuses ON/OFF during periodic printout.
<Related Topics> Turning Periodic Printout ON and OFF and Setting the Interval: Section 4.8
To Next Page
Loading...
Need help?
General
