YOKOGAWA SR10000 series User Manual

4-22
IM 04P03B01-01E
4.16 Changing the Time Printout Format
The time printout format can be changed on the alarm printout, message printout,
recording start printout, and new chart speed printout. Basic Setting mode cannot be
entered when recording is in progress.
Procedure
1. Hold down the
MENU
key for 3 seconds to enter Setting mode.
2. Hold down the and keys simultaneously for 3 seconds to display the
Basic Setting mode screen.
3. Carry out the procedure shown in the figure below.
Press the
or key to select the value.
If you press the
key, the operation is cancelled, and the display returns to a
higher level menu.
Select “T_PRN.”
(T_PRN)
(ALARM)
(HM)
(MSG)
(HM)
(RCD)
(HM)
(SPEED)
(HM)
The settings are activated.
(OK)
Alarm printout
Select the time printout format.
Message printout
Select the time printout format.
Recording start printout
Select the time printout format.
New chart speed printout
Select the time printout format.
4. If you are done, press the key.
5. To return to the Operation mode,
1. Press the key, use the or key to select , and press the
key.
2. Press the or key to select or , and press the
key.

YOKOGAWA SR10000 series Specifications

General

Brand	YOKOGAWA
Model	SR10000 series
Category	Measuring Instruments
Language	English