4-16
IM 04P03B01-01E
4.11 Enabling the Filter Function (Pen Model)
The input filter function on the pen model can be enabled/disabled. Basic Setting mode
cannot be entered when recording is in progress.
Procedure
1. Hold down the
MENU
key for 3 seconds to enter Setting mode.
2. Hold down the and keys simultaneously for 3 seconds to display the
Basic Setting mode screen.
3. Carry out the procedure shown in the figure below.
Press the
or key to select the value.
If you press the key, the operation is cancelled, and the display returns to a
higher level menu.
The settings are activated.
Select whether to use the filter function.
Select “FILTR.”
(FILTR)
(NOT)
(OK)
4. If you are done, press the key.
5. To return to the Operation mode,
1. Press the key, use the or key to select , and press the
key.
2. Press the or key to select or , and press the
key.
Explanation
Filter
Enable (
): Enables the setting of the filter and the time constant in Setting mode.
Disable ( ): The “FILTR” item does not appear in Setting mode.
<Related Topics> Setting the filter: Section 3.2
To Next Page
Loading...
Need help?
General
