5-43
IM 760301-01E
5
Power Measurement
• Integrating in Real-time Normal Integration Mode or Real-time Repetitive
Integration Mode
• Starting the Integration
19. Press INTEG to display the Integ menu.
20. Press the START soft key. The START indicator to the right of the INTEG key
illuminates and the instrument enters the ready condition. When the reservation
time for starting the integration is reached, the START indicator changes to
illumination and the integration is started.
• Holding the Integration
21. Press HOLD. The HOLD key illuminates, and the numeric data display is held.
Integration continues.
• Releasing the Hold Operation
22. Press HOLD while the values are held. The HOLD key turns OFF, and the
numeric data display is updated. In the hold condition, the display can be
updated by carrying out single measurements (by pressing SINGLE).
• Stopping the Integration
23. Press the STOP soft key. The START indicator turns OFF and the STOP
indicator illuminates. The integration time and integration value are held. If you
press STOP before the time specified by the integration timer is reached and
then press START, integration continues up to the time specified by the
integration timer.
If the reservation time for stopping the integration is reached in the real-time
normal integration mode, the START indicator turns OFF and the STOP
indicator illuminates. The integration time and integration value are held.
If the time specified by the integration timer elapses in the real-time repetitive
integration mode, the integration time and integration value are automatically
reset, and the integration is repeated until STOP is pressed or when the
reservation time for stopping the integration is reached..
• Resetting the Integration
24. Press the RESET soft key. The STOP indicator turns OFF, the integration time
and integration value are reset, and the display shows [-------] (no data).
5.14 Setting the Real-Time Integration and Real-Time Repetitive Integration
To Next Page
Loading...
Need help?
General
