9-9
IM 760301-01E
9
Saving and Loading Data
• Setting the Items One at a Time
6. Press the cursor keys to select the element or measurement function that you
wish to specify.
7. Press SET. When the button to the left of the selected element or measurement
function is highlighted, the numeric data of the measurement function of the
element will be saved. When the highlighting of the button is cleared, the
numeric data of the measurement function of the element will not be saved.
Proceed to step 10 on page 9-10.
Selecting the Waveform Sampling Data
• Selecting the Type of Waveform Sampling Data to Be Saved
4. Press the Data Type soft key to display the Data Type menu.
5. Press one of the keys from Binary to Float to select the data type.
• Selecting the Input Signals to Be Saved
The input signal selection box appears only when you select Float in step 5. (When
the data type is set to Binary or ASCII, the waveform that is displayed on the screen is
saved.)
6. Press the Save soft key to display the Save Menu menu.
7. Press the Trace soft key to display the input signal selection box.
8. Press the cursor keys to select any of the elements/wiring units starting with
U1.
9. Press SET to select the input signal to be saved.
Proceed to step 12 on page 9-10.
9.3 Saving Setup Parameters, Waveform Display Data, Numeric Data, Waveform Sampling Data
To Next Page
Loading...
