9-8 IM 760301-01E
Selecting the Numeric Data
• Selecting the Type of Numeric Data to Be Saved (for Measurement Modes Other
Than Cycle-by-Cycle)
4. Press the Data Type soft key to select ASCII or Float.
Note
The data type is fixed to ASCII for the cycle-by-cycle measurement.
• Selecting the Numeric Data to Be Saved
5. Press the List Item soft key to display the List Item dialog box.
• Selecting All Items at Once
6. Press the cursor keys to select All ON.
7. Press SET. The buttons to the left of all the elements and measurement
functions are highlighted indicating that all items will be saved.
• Deselecting All Items at Once
6. Press the cursor keys to select All OFF.
7. Press SET. The highlighting of the buttons to the left of all the elements and
measurement functions are cleared indicating that all items will not be saved.
Cycle-by-cycle measurement
• Selecting Only the Items That Are Preset (during Normal Measurement Only)
6. Press the cursor keys to select Preset1 or Preset2.
7. Press SET. The buttons to the left of all the elements and measurement
functions that are specified in Preset1 or Preset 2 are highlighted indicating that
the items will be saved.
Items specified in Preset1 Items specified in Preset2
9.3 Saving Setup Parameters, Waveform Display Data, Numeric Data, Waveform Sampling Data
To Next Page
Loading...
