Accessories
137
Hand Strap
NOTE: Requires rugged boot.
The hand strap provides securing when holding the device.
To install the hand strap on the device:
1. Feed the top and bottom ends of the hand strap through the slots at the top and bottom of the rugged
boot.
2. Pull the ends of the hand strap through the slots.
3. Press the hook material against the loop material on both ends of the hand strap.
4. Place hand between device and hand strap and adjust hand strap as necessary.
When adjusting the hand strap, do not pull the loop material too far through the slots.
To Next Page
Loading...