Application Deployment
218
2. Connect the cable or cradle to the host computer.
3. On the device, swipe down from the Status bar to open the Quick Access panel and then touch .
4. Touch System > Developer options.
5. Slide the switch to the ON position.
6. Touch USB Debugging. A check appears in the check box. The Allow USB debugging? dialog box
appears.
7. Touch OK.
8. On the host computer, open a command prompt window and use the adb command:
adbrebootrecovery
9. Press Enter. The System Recovery screen appears.
10.Tap the touch panel to advance to the next choice and navigate to apply upgrade from adb.
11.Press the Scan button.
12.On the host computer, open a command prompt window and use the adb command:
adbdevices.
The following displays:
Listofdevicesattached
XXXXXXXXXXXXXXXdevice
(where XXXXXXXXXXXXXXX is the device number).
NOTE: If device number does not appear, ensure that ADB drivers are installed properly.
13.Type:
adbrebootrecovery
14.Press Enter. The System Recovery screen appears.
15.Tap the touch panel to advance to the next choice and navigate to apply upgrade from adb.
16.Press the Scan button.
17.Navigate to Full OTA Package.
18.Press the Scan button.
19.On the host computer command prompt window type:
adbsideload<file>
where: <file> = the path and filename of the zip file.
20.Press Enter. The Factory Reset package installs and then the Recovery screen appears.
21.Press the Scan button to reboot the device.Replace the top cover.
Storage
The device contains four types of file storage:
• Random Access Memory (RAM)
• On-device Storage
• Internal storage
To Next Page
Loading...
Need help?
General
