Zebra PS20 Series

Getting Started
47
3. Release the Scan key.
4. Briefly press and release the Scan key.
The device reboots.
When Out of the Cradle
To perform a hard reset when the device is out of the cradle:
1. Insert the Terminal Reboot Tool into the Power Connector.
Figure 27 Terminal Reboot Tool
2. Press and hold the Scan key for 10 seconds until the display powers off.
3. Release the Scan key.
4. Remove the Terminal Reboot Tool.
5. Briefly press and release the Scan key.
The device reboots.
Terminal Reboot Tool
Scan Key
Power Connector