P1036102-007 ZXP Series 7 Card Printer Service Manual 107
Replacement Procedures for the Printer
Procedures: Print Engine
Step 3. From the back of the Print Engine: With a TORX T10 driver, remove the two
screws holding the Ribbon Close Outs in place. Note the ground wires
connections for reassembly.
Step 4. Carefully lift the Ribbon Close Outs and associated springs out of the Print
Engine; The Tricolor Ribbon Sensor is attached to the right Ribbon Close
Out.
Step 5. Set the Ribbon Close Outs aside.
To Next Page
Loading...
