Zebra ZXP 7 series

368 ZXP Series 7 Card Printer Service Manual P1036102-007
Cleaning
Cleaning the Laminator
Clean the Laminator Media Rollers
Note • Recommend doing this at power up when the Laminator is already cold rather
than waiting for it to cool down to 140°F (60°C).
Step 1. From the Clean Printer Menu, select CLEAN LAM ROLLERS to run the
Laminator Media Roller Cleaning Routine; and follow the OCP instructions.
Step 2. Wait until the oven temperature falls below 140°F (60°C).
Step 3. Open the laminator covers, remove the laminate (top and bottom cassettes),
and leave both covers open.
Step 4. Prepare a Cleaning Swab for use.
Step 5. Locate the top roller (circled below) for the upper cassette.
Step 6. When ready, press Next; and then press Top.
Step 7. Clean the top media roller by moving the swab tip side-to-side until roller
stops turning. Only use moderate pressure.