Zebra ZXP 7 series

218 ZXP Series 7 Card Printer Service Manual P1036102-007
Replacement Procedures for the Laminator
Required Tools
Required Tools
This section lists the tools required for the replacement procedures described in this
section. Naturally, not all tools are required for a particular procedure; specific tools
are called out in each step as appropriate.
• Flat-blade Screwdrivers, from 1/16 inch (1.5 mm) to 1/4 inch (6.5 mm)
• Phillips #0, #1 Screwdriver
• TORX T10, T15 Driver (standard, 8-inch shaft, and/or ball-end; magnetic tip
recommended)
• Adjustable Wrench
• Fine-Point, Oset Fine-Point, and Needle-Nose Pliers
• Small Diagonal Cutters or other cutter for cutting cable ties
• 5.5 mm Hex Driver (this can also be used for securing push nuts)
• 3–10 mm E-Ring Clip Tool
• Small and Medium Spring Hook Tools
• Cotton Gloves