Zebra ZXP 7 series Service Manual

290 ZXP Series 7 Card Printer Service Manual P1036102-007
Replacement Procedures for the High-Capacity Output Hopper
Required Tools
Required Tools
This section lists the tools required for the replacement procedures described in this
section. Naturally, not all tools are required for a particular procedure; specific tools
are called out in each step as appropriate.
• TORX T10 driver (short and long shafts)
• Small diagonal cutters or other cutter for cutting cable ties
• 5.5 mm nut driver

Zebra ZXP 7 series Specifications

General

Print Resolution	300 dpi
Connectivity	USB 2.0, Ethernet
Memory	64 MB standard
Print Technology	Dye-sublimation thermal transfer
Card Capacity	200 cards input hopper, 100 cards output hopper
Card Sizes	CR-80 ISO 7810, 2.12" (54 mm) x 3.38" (86 mm)
Power Requirements	100-240 VAC, 50-60 Hz