Zebra ZXP 7 series Service Manual

P1036102-007 ZXP Series 7 Card Printer Service Manual 187
Replacement Procedures for the Printer
Procedures: Torque Tools Calibration Instructions
Torque Tools Calibration Instructions
This kit will allow users to calibrate the Torque Tools (Low Torque and High Torque) in
Kit, Torque Adjustment for RTU Motor Calibration.
Note that the Torque Watch and the Turntable are not included and need to be
supplied by the user.
Parts List
P1037750-405: Kit Knob and Spindle for Torque Calibration ZXP7
QTY DESCRIPTION
1 KNOB, TORQUE TOOL TURNTABLE
1 SPINDLE, RIBBON
1 SHAFT, SPINDLE, RIBBON
1 SCR, PAN HD, TORX+, M3X6
1 WASHER, LOCK, INT TOOTH, M3
Special Tools
• Torque Tools: Zebra Kit
• Torque Watch: Waters® 651X-3, Tohnichi ATG18Z, or other
• Turntable (motor must be rated at 30 RPM)

Zebra ZXP 7 series Specifications

General

Print Resolution	300 dpi
Connectivity	USB 2.0, Ethernet
Memory	64 MB standard
Print Technology	Dye-sublimation thermal transfer
Card Capacity	200 cards input hopper, 100 cards output hopper
Card Sizes	CR-80 ISO 7810, 2.12" (54 mm) x 3.38" (86 mm)
Power Requirements	100-240 VAC, 50-60 Hz