Zebra ZXP 7 series Service Manual

146 ZXP Series 7 Card Printer Service Manual P1036102-007
Replacement Procedures for the Printer
Procedures: Ground Plate
Step 3. Remove the two power connections. Note that the blue wire is on the
bottom connector.
Step 4. With a TORX T10 driver, remove the six screws holding the Ground Plate to
the Frame.
Step 5. Set the Ground Plate aside.

Zebra ZXP 7 series Specifications

General

Print Resolution	300 dpi
Connectivity	USB 2.0, Ethernet
Memory	64 MB standard
Print Technology	Dye-sublimation thermal transfer
Card Capacity	200 cards input hopper, 100 cards output hopper
Card Sizes	CR-80 ISO 7810, 2.12" (54 mm) x 3.38" (86 mm)
Power Requirements	100-240 VAC, 50-60 Hz