P1036102-007 ZXP Series 7 Card Printer Service Manual 39
Replacement Procedures for the Printer
Procedures: Feeder Cartridge
Reassembly
Step 1. For proper lock orientation, install the replacement lock with key inserted
slightly, teeth up.
Step 2. Continue installing the replacement Lock Assembly by reversing the
removal steps.
Step 3. Reassemble the Feeder Cartridge as follows:
a. Fit the Side Cover into the slots in the Bottom Cover; ensure that the rod
fits into the alignment hole in the Side Cover.
b. With a TORX T10 driver, install the two screws holding the Side Cover in
place.
c. Fit the Top Cover onto the Bottom Cover; the pieces will “snap” together.
d. With a TORX T10 driver, install the five screws on the bottom of the
Feeder Cartridge.
To Next Page
Loading...
