ZyXEL Communications N4100 - Page 177

Chapter 21 Session Trace
N4100 User’s Guide
177
The following table describes the labels in this screen.
Table 41 ADVANCED > SESSION TRACE
LABEL DESCRIPTION
Session Trace Enable the session trace feature to record the destination IP address,
destination port, source IP address, source MAC address and source port
of every subscriber session. The N4100 sends the collected information in
a text file to the destination(es) that you specify below.
Disable the session trace feature to not record and send details about the
Internet access activity of your subscribers.
Send Session
Trace log file
every~
minutes.
Enter the time interval (minutes) for how often you want the N4100 to
send the session trace log file.
Note: The N4100 will also automatically send the log file whenever
the log has 50 entries.
The N4100 clears the session trace record after sending a log file.
Send to TFTP
Server
Enable Select the check box to have the N4100 send the session trace log file to
the TFTP server that you specify.
Primary
TFTP
Server IP
Address
Enter the IP address of the first TFTP server in dotted decimal notation.
Secondary
TFTP
Server IP
Address
Enter the IP address of the second TFTP server in dotted decimal
notation.
Send to E-mail
Server
Enable Select the check box to have the N4100 send the session trace log file to
the e-mail account that you specify.
Email Server
IP Address
or Domain
Name
Enter the IP address or domain name of the mail server for the e-mail
addresses specified below. If this field is left blank, the syslog will not be
sent via e-mail.
SMTP Port Enter the port number (25, or between 2500 and 2599) for the mail
server. The default is 25.
Enable E-
mail
(SMTP)
server
needs to
check my
account
Select this check box if your SMTP server requires user name and
password authentication before accepting e-mail. Your network
administrator, SMTP server provider or ISP should supply the username
and password.
Username Enter the username for the SMTP server.
Password Enter the password for the SMTP server.
Email From
Name Type a name that you want to be in the “message from” field of the log e-
mail message that the N4100 sends.