Chapter 23 SNMP
N4100 User’s Guide
185
The following table describes the fields in this screen.
Table 46 ADVANCED > SNMP
LABEL DESCRIPTION
SNMP Setup Select Enable to allow a manager station to manage and monitor the
N4100 through the network via SNMP. Otherwise, select Disable.
Port
SNMP Port Enter the N4100’s port number to which the manager station sends
requests.
Trap Port Enter the port number on which the manager station listens for SNMP
traps and information from the N4100.
Configuration
No This is the index number of the entry.
Community
Name
Enter the password for the incoming Get, GetNext or Set requests
from the management station. The default community for read-only
access is public and the default community for read-write access is
private.
NMS Address Enter the IP address of the Network Management System (NMS) that
controls and monitors the managed device (N4100).
ANY means any computer that connects to the N4100 can request
SNMP information and/or receive traps from the N4100.
Privileges Select the privilege level of the password.
Read means the password is for read-only (Get or GetNext) access.
Write means the password is for read-write (Get/GetNext and Set)
access.
Trap Recipient means the password is for accepting SNMP traps from
the N4100.
All means the password has all the above permissions.
Status Select whether this password is valid or not.
Apply Click this button to save your changes back to the N4100.