3D Systems ProX DMP320 User Manual

613D SYSTEMS, INC.
10. Remove print platform by loosening the four corner
bolts with a 5mm hex key.
11. When all four bolts have been removed, put them
somewhere you will remember for later.
12. Lift platform up at an angle and let excess powder fall
into bin as shown.
13. Continue removing the excess powder by tapping the
back of the print platform with a rubber mallet.

3D Systems ProX DMP320 Specifications

General

Brand	3D Systems
Model	ProX DMP320
Category	3D Printers
Language	English