ABB AC 800M

Tabl e 18. Electronic Key Parameters
Parameter
Default
Va
lue
Data
Type
Description
Electronic Key
V
endorID
Disable
Keying
Enum When enabled, there will be a check to see if the
Vendor ID of the configured slave in Control Builder
matches with that of the device in the network, before
connection establishment.
Values are: Enable Keying, Disable Keying
Electronic Key
Pr
oduct Type
Disable
Keying
Enum When enabled, there will be a check to see if the
Product Type of the configured slave in Control Builder
matches with that of the device in the network, before
connection establishment.
Values are: Enable Keying, Disable Keying
Electronic Key
Pr
oduct Code
Disable
Keying
Enum When enabled, there will be a check to see if the
Product Code of the configured slave in Control Builder
matches with that of the device in the network, before
connection establishment.
Values are: Enable Keying, Disable Keying
Electronic Key
Ma
jor
Revision
Disable
Keying
Enum When enabled, there will be a check to see if Major
Revision of the configured slave in Control Builder
matches or is higher than that of the device in the
network before connection establishment.
Values are: Disable Keying, Exact Match,
Current and Higher
Section 4 Configuration Communication Related Parameters
9ARD000014-600 A 125
Communication Related Parameters
Communication related parameters have a bearing on the communication between
the DeviceNet device and the linking device LD 800DN. The communication
related parameters depend on the type of connection trigger types supported by the
slave device. The four possible connection types that can be supported by a device
are:
• Poll Connection (see Poll Connection on
page 126)