ABB AC 800M

Section 4 Configuration Configuration Recovery Parameter
9ARD000014-600 A 131
Configuration Recovery Parameter
The Config Recovery parameter allows users to explicitly enable or disable the
Configuration Recovery feature for each DeviceNet slave unit. This parameter
appears in the hardware editor of every DeviceNet slave unit.
Refer Automatic Device Recovery on page 210, to know more about Configuration
Recovery.
Conn Cyclic
InputSize
Depends
on the
device
support
as stated
in its EDS
file
Int Read Only Number of bytes of data that gets
transferred from the device to the linking
device over the Cyclic connection.
Conn Cyclic
OutputSize
Depends
on the
device
support
as stated
in its EDS
file
Int Read Only Number of bytes of data that gets
transferred from linking device to the device
over the Cyclic connection.
Table 22. Cyclic Connection Parameters (Continued)
Parameter
Default
Value
Data
Type
Read Only /
Editable
Description