7. Cut an adequate hole into the rubber grommet. Slide the grommet onto the
cable.
8. Prepare the ends of the cables as shown in the figure. Two different motor
cable types are shown. If you use aluminum cables, put grease onto the peeled
aluminum cable before you connect it to the drive.
Note: The bare shield will be grounded 360°.
Only allowed for input cabling with phase
conductor cross-section less than 10 mm
2
(8 AWG)
9. Put the cable through the hole of the cable entry plate and attach the grommet
to the hole.
Electrical installation – IEC 105
To Next Page
Loading...
