Mechanical installation
￭
Necessary tools
• Screwdriver and a set of suitable bits.
￭
Unpacking and examining the delivery
1. Open the option package. Make sure that the package contains:
• the option module
• a mounting screw.
2. Make sure that there are no signs of damage.
￭
Installing the module
See section Installing option modules (page 115).
Electrical installation
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
Stop the drive and do the steps in section Electrical safety precautions (page 20)
before you start the work.
￭
Necessary tools
• Screwdriver and a set of suitable bits.
￭
Wiring
Connect the external cables to the applicable module terminals. Ground the outer
shield of the cables to the SHIELD terminal.
CAIO-01 bipolar analog I/O adapter module 257
To Next Page
Loading...
