ABB ACH580-31 - Installing Option Modules; Option Slot 2 (I;O Extension Modules)

Installing option modules
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
1. Stop the drive and do the steps in section Electrical safety
precautions (page 20) before you start the work.
￭
Option slot 2 (I/O extension modules)
1. Put the module carefully into its position on the control unit.
2. Tighten the mounting screw.
3. Tighten the grounding screw (CHASSIS) to 0.8 N·m (7 lbf·in). The screw grounds
the module. This is necessary for fulfilling the EMC requirements and for correct
operation of the module.
1
2
3
Electrical installation – IEC 115