Safety
WARNING!
Frames R6 and R8: Lift the drive with a lifting device. Use the lifting eyes of
the drive. Do not tilt the drive. The drive is heavy and its center of gravity
is high. An overturning drive can cause physical injury.
Examining the installation site
Examine the installation site. Make sure that:
• The installation site is sufficiently ventilated or cooled to remove heat from
the drive. See the technical data.
• The ambient conditions of the drive meet the specifications. See the technical
data.
• The material behind, above and below the drive is non-flammable.
• The installation surface is as close to vertical as possible and strong enough
to support the drive.
• There is sufficient free space around the drive for cooling, maintenance, and
operation. See the free space specifications for the drive.
• Make sure that there are no sources of strong magnetic fields such as
high-current single-core conductors or contactor coils near the drive. A strong
magnetic field can cause interference or inaccuracy in the operation of the
drive.
Installation positions
There are three alternative ways to install the drive:
• vertically alone. Do not install the drive upside down.
44 Mechanical installation
To Next Page
Loading...
