SeeTask
Electrical installation – IEC (page 91) or Elec-
trical installation – North America
(NEC) (page 119)
Connect the control cables.
Installation checklist (page 147)
Check the installation.
Firmware manual
Commission the drive.
Quick start-up guide for the drive
Terms and abbreviations
DescriptionTerm
Assistant control panel with Hand-Off-Auto functionalityACH-AP-H
Assistant control panel with Hand-Off-Auto functionality and
Bluetooth interface
ACH-AP-W
A network protocol (Building Automation and Control Networks)BACnet™
Conducts the surplus energy from the intermediate circuit of the
drive to the brake resistor when necessary. The chopper operates
when the DC link voltage exceeds a certain maximum limit. The
voltage rise is typically caused by deceleration (braking) of a high
inertia motor.
Brake chopper
Dissipates the drive surplus braking energy conducted by the brake
chopper to heat
Brake resistor
The capacitors connected to the DC linkCapacitor bank
Configuration adapterCCA-01
Type of control unitCCU
Communication adapter moduleCDPI-01
115/230 V digital input extension moduleCHDI-01
Multifunction extension module (external 24 V AC/DC and digital
I/O extension)
CMOD-01
Multifunction extension module (external 24 V AC/DC and isolated
PTC interface)
CMOD-02
The part in which the control program runs.Control unit
Multifunction extension module (external 24 V and ATEX/UKEX-cer-
tified PTC interface)
CPTC-02
DC circuit between line-side converter and motor-side converterDC link
Energy storage which stabilizes the intermediate circuit DC voltageDC link capacitors
Optional mounting platform for door mounting of control panelDPMP
Mounting platform for control panel (flush mounting)DPMP-01
Mounting platform for control panel (surface mounting)DPMP-02, DPMP-03
Introduction to the manual 27
To Next Page
Loading...
