ABB ACH580-31 - Connecting the Control Cables; Connection Diagram; Connection Procedure

12. Install the shroud onto the power cable connection terminals.
R8
R
6
Connecting the control cables
￭
Connection diagram
See section Default I/O connection diagram (page 137).
￭
Connection procedure
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
1. Stop the drive and do the steps in section Electrical safety
precautions (page 20) before you start the work.
2. Remove the front cover(s) if not already removed.
3. For frame R3: Pull the control panel holder up.
128 Electrical installation – North America (NEC)