Parameters 103
Summary of parameter groups
Group Contents Page
01 Actual values Basic signals for monitoring the drive. 108
03 Input references Values of references received from various sources. 111
04 Warnings and faults Information on warnings and faults that occurred last. 112
05 Diagnostics Various run-time-type counters and measurements related to
drive maintenance.
114
06 Control and status words Drive control and status words. 117
07 System info Drive hardware and firmware information. 122
10 Standard DI, RO Configuration of digital inputs and relay outputs. 123
11 Standard DIO, FI, FO Configuration of the digital input/outputs. 127
12 Standard AI Configuration of standard analog inputs. 131
13 Standard AO Configuration of standard analog outputs. 136
19 Operation mode Selection of local and external control location sources and
operating modes.
140
20 Start/stop/direction Start/stop/direction and run/start/jog enable signal source
selection; positive/negative reference enable signal source
selection.
142
21 Start/stop mode Start and stop modes; emergency stop mode and signal source
selection; DC magnetization settings.
152
22 Speed reference selection Speed reference selection; motor potentiometer settings. 160
23 Speed reference ramp Speed reference ramp settings (programming of the acceleration
and deceleration rates for the drive).
170
24 Speed reference
conditioning
Speed error calculation; speed error window control configuration;
speed error step.
175
25 Speed control Speed controller settings. 175
26 Torque reference chain Settings for the torque reference chain. 181
28 Frequency reference chain Settings for the frequency reference chain. 185
30 Limits Drive operation limits. 197
31 Fault functions Configuration of external events; selection of behavior of the drive
upon fault situations.
205
32 Supervision Configuration of signal supervision functions 1…3. 214
35 Motor thermal protection Motor thermal protection settings such as temperature
measurement configuration, load curve definition and motor fan
control configuration.
221
36 Load analyzer Peak value and amplitude logger settings. 228
37 User load curve Settings for user load curve. 231
40 Process PID set 1 Parameter values for process PID control. 235
41 Process PID set 2 A second set of parameter values for process PID control. 249
44 Mechanical brake control Configuration of mechanical brake control. 252
45 Energy efficiency Settings for the energy saving calculators. 253
46 Monitoring/scaling settings Speed supervision settings; actual signal filtering; general scaling
settings.
257
47 Data storage Data storage parameters that can be written to and read from
using other parameters’ source and target settings.
261
49 Panel port communication Communication settings for the control panel port on the drive. 262
ACS180 FW.book Page 103 Tuesday, March 9, 2021 2:25 PM
To Next Page
Loading...
